Well And Septic System Cost

Installation of a well and septic system. On average, a septic system will cost $3,280 to $5.040 to install. On average, a well and septic system will cost between $3,280 and $5,040 to install. This depends on what type of system you choose, the size of your absorption field, the depth of the well drilling, and how large the tank is. However, an average cost of $5,000 to $10,000 should be expected. If your soil composition is poor and there is not enough ground water, the cost could rise to as high as $40,000.

Septic System Cost Guide

  • Types of septic systems
  • Type of soil
  • Leach Field
  • Septic Tank
  • Septic Tank Riser
  • Septic Pipes
  • Permit Costs
  • Septic System Engineering (Design and Installation).
  • Maintenance costs

Septic Systems

The septic system will include a tank to hold and treat wastewater from your home. It will also include the plumbing connections between the tank and the leach fields, where effluent is sent after it has been broken down. Although you might be able to complete this test yourself, many areas have strict guidelines that require professionals. This test costs between $1,000 and $1,500. You will need to trust that the soil results are good enough to install a septic tank.

Guide To The Cost Of A Septic Tank

The cost of a septic tank depends on the size and type of tank used. An 800 gallon Septic Tank would be suitable for a two-bedroom house. There will be less daily wastewater than, say, a four-bedroom house that might require a 1200-Gallon tank.

Well Systems

Due to the required permit and the special equipment, drilling a well by yourself is impossible. It costs between $15 and $30 to drill the well and place the casing of four to six inches inside. However, depending on who you hire, it could be higher.
This example is for a 100-foot well. While the cost would range from $1,500 to $3,000, it would not include any permit fees. These fees vary by area so we cannot share their costs with you. You will also need a water conditioning system if you have water that needs to be treated. These systems can run from $1,500 to $3,000, and you’ll still have to pay for any drilling done by the person, even if there is no water. You should be very careful about where they drill. If they don’t find water at 100ft and have to drill 100ft further, you could end up paying between $3,000-$6,000. You will also need to pay between $6,000-$12,000 if they have to drill 400 feet before hitting water.

Cost of Well Caps and Seals

To protect your well from contamination, sealing or capping a well can cost $20-40.

  • The gasket seals the water and power lines through sealed wells.
  • Capped wells have underground water and power lines. If the frost line is more than 3-4 feet deep in northern regions, a sanitary well cap will be placed above the ground. The pump will then be suspended from a pitless adapter beneath the frostline.

Cost Of A Well Water Storage Tank

Well water storage tanks cost between $104 and $714 for a 2-gallon container to store well water. Water tanks or pressure tanks are used to draw water from the well. They keep the water under pressure and are delivered when an appliance or faucet is used in your home.

Leave a Reply

Your email address will not be published. Required fields are marked *