Quick4 Plus Standard Low Profile Chamber

Quick4 Plus Low Profile Chamber

Through its four central structural columns, the Quick4 Plus, Standard Low Profile, offers maximum strength. This chamber can fit in a 36 inch trench. This chamber is smaller in height than Infiltrator Standard model chambers. It can be installed easily. It is similar to the original Quick4 chambers and offers advanced contouring capabilities with its Contour Swivel Connection, which allows turns of up to 10 degrees, right or left.

The Quick4+ All-in-One8 and Quick4+ End Caps allow for greater flexibility in system design.

Product Details

  1. This chamber is ideal for applications that require a low profile.
  2. Imported fill required for fill and cap systems is reduced
  3. Superior strength is provided by four central structural columns
  4. Advanced contouring connections
  5. Installation is quick and easy with the latch mechanism
  6. The 4ft lengths of the chambers are simple to install and handle.
  7. Supports wheel loads up to 16000 lbs/axle and 12 inches of cover

Benefits

  1. This chamber is ideal for applications that require a low profile.
  2. Imported fill required for fill and cap systems is reduced
  3. Superior strength is provided by four central structural columns
  4. Advanced contouring connections
  5. Installation is quick and easy with the latch mechanism
  6. Easy to install and handle chambers measuring four feet long
  7. Supports wheel loads up to 16,000 lbs/axle and 12″ of cover
  8. You can use this to install an outlet/inlet at the end or mid-trench.
  9. The mid-trench connection feature allows chamber rows to be inlet from the center.
  10. You can choose from a variety of pipe connections to allow you to inlet side-by-side, end-by-end or top.
  11. Are you looking for drilling points?
  12. Set for gravity or pressure pipe
  13. Simple, flat design *
  14. Allows for the installation of a pipe only from the end
  15. The piping drill points are for pressure or gravity pipe

What Types Of Systems Can Infiltrator Chambers Be Installed?

Infiltrator chambers are suitable for almost all septic leach fields. Infiltrator chambers are able to be used wherever stone and pipe can fit. These include trench, bed and elevated mound installation. Infiltrator chambers offer superior treatment capabilities for pressure dosing and serial distribution.

Chambers Can Be Installed Under A Driveway, Or Paved Surface

Some codes prohibit the installation of septic leach fields under impervious surfaces, such as driveways. The reason is that the soil can be compressed by the pressure of the surface, which can cause a decrease in its ability to filter effluent (wastewater). For the exact codes applicable to your area, check with your local health department. For design and installation instructions, contact Infiltrator Water Technologies’ Technical Services team

Long Are Infiltrator Quick4 Plus Standard Chambers

The four-foot chamber lengths can be easily installed and handled. With 12″ of cover, supports wheel loads up to 16,000 lbs/axle. International Association of Plumbing and Mechanical Officials (IAPMO) certified.

Quick4 Deep Should Infiltrator Chambers

Infiltrator Water Technologies recommends that the chambers have a minimum of 12 inches of covered compacted material. The maximum allowable cover for chambers in trench systems is 96 inches. Maximum cover in bed systems is 48 inches

What Length Of Leaching Chamber Is Required?

When using a traditional drainfield trench, the minimum length of the leaching chamber system must be determined by dividing its total trench area by 1.2 metres (4 feet).

Need To Have Feet Of Leaching Chamber

When using a traditional drainfield trench, the minimum length of the leaching chamber system must be determined by dividing its total trench area by 1.2 metres (4 feet).

Septic Chambers Are Measured In Terms Of Size

A typical residential septic system is approximately 4.5 feet in width, 8.0 feet long, and 6 feet high. The size of your septic tank might be different. However, the Quick4 Plus Standard Low Profile (LP), offers maximum strength due to its four central structural columns. This chamber is 36 inches wide and can be placed in a 36 inch-wide trench. This chamber is smaller than. The chambers of Infiltrator are also available in Standard models. The Quick 4 Plus Standard Low Profil Chamber can fit in a 36″‘.

Leave a Reply

Your email address will not be published. Required fields are marked *