Nissan Altima Conditions the Remote Start Will Not Work

Nissan Altima Owners Manual: Conditions the remote start will not work

The remote start feature in Nissan Altima may fail to operate under various conditions. It’s essential for Altima owners to be aware of these conditions to ensure proper functionality. Here are the key factors affecting remote start:

Ignition Switch Position

The remote start will not function if the ignition switch is in the ON position.

Hood Status

Ensure that the hood is securely closed for the remote start to work.

Hazard Warning Lights

If the hazard warning lights are on, the remote start will be disabled.

I–Key Indicator Light

If the I–Key Indicator Light remains solid in the vehicle information display, the remote start will not operate.

Illegal Entry Alarm

The alarm triggered by illegal entry into the vehicle will prevent remote start.

Intelligent Key Position

If the ignition switch is pushed without an Intelligent Key in the vehicle, or if it’s pushed with an Intelligent Key but the brake pedal is not depressed, remote start won’t work.

Previous Remote Starts

Two remote starts or a single remote start with an extension should not exceed the limit.

Gear Shift Position

The vehicle must be in P (Park) for the remote start to function.

Settings in Vehicle Display

Ensure that the Remote Start function is set to ON in Vehicle Settings.

RES Service Information for Nissan Altima

In case the Remote Engine Start (RES) feature is reported as “not working,” Nissan provides specific service information for qualified technicians. Follow these steps to troubleshoot and verify the system’s operation:

Pre-Check Conditions

  1. Verify that the ignition is OFF.
  2. Confirm the RES function is ON in Vehicle Settings.
  3. Ensure the shift selector is in Park (P).
  4. Confirm closure of hood, doors, trunk lid, and lift gate.
  5. No other Intelligent Keys should be inside the vehicle.
  6. The Intelligent Key must be within the operating range.

Operating the RES

  1. Point the Intelligent Key at the vehicle.
  2. Press the LOCK button.
  3. Press and hold the RES button within five seconds of pressing the LOCK button until signal lights flash and tail lamps turn on.

Troubleshooting with Diagnosis Table

Refer to the Supplemental Diagnosis Table for possible causes and resolutions if the RES feature is not working correctly. Follow the steps outlined in the table to address specific issues.

Common Issues and Solutions for Remote Start Systems

Remote Start Not Working? 10 Common Remote Start Issues and How to Fix Them

Remote car starters enhance comfort, especially in cold weather. However, issues may arise with aftermarket systems. Here are common problems and their solutions:

1. Incorrect Remote Usage

Different remotes have varied starting procedures. Review the manual to ensure proper usage.

2. Fob Battery Check

Replace the key fob battery if lock and unlock buttons are finicky, impacting remote start functionality.

3. Gear Shift Position

Ensure the vehicle is in “Park” for the remote start to activate.

4. Key Fob Placement

Remove the regular key fob from the vehicle; it may interfere with remote start.

5. Multiple Start Attempts

Avoid quick, successive remote starts; reset by inserting the key and turning it to “ON” and then “OFF.”

6. Hood Safety Feature

Check the hood status; a safety feature may prevent remote start if the hood is unlatched.

7. Hazard Lights

Turn off hazard lights as they can disable the remote start.

8. Coolant and Oil Levels

Check and address high coolant temperature or low oil pressure before attempting a restart.

9. Valet Mode

Verify if the remote starter is in valet mode; consult the owner’s manual for disengagement instructions.

10. Remote Starter Switch

Check for a remote starter switch; ensure it’s in the “ON” position for normal system operation.

Leave a Reply

Your email address will not be published. Required fields are marked *